Prepared Ground

Layers · Well Depth

Well depth by state.

How deep the typical water well goes in every state, from the USGS record of catalogued wells. On raw land the well is often the largest single cost of making a parcel livable: at $30–60 a foot, a 90 ft well and a 650 ft well are $20,000–35,000 apart before the pump.

Shallowest typical wells: Maine (46 ft), Kansas (60 ft), Rhode Island (60 ft), Massachusetts (65 ft), Oklahoma (67 ft). Deepest: Georgia (280 ft), Hawaii (263 ft), Virginia (260 ft), Missouri (260 ft), South Carolina (252 ft).

Typical well depth by state. Each county's figure is the median depth of its catalogued wells; the state figure is the median across its counties.
State Typical well Counties ≤150 ft Counties ≥400 ft Counties with data
Alabama 146 ft 53% 9% 64 of 67
Alaska 78 ft 90% 0% 21 of 30
Arizona 223 ft 33% 20% 15 of 15
Arkansas 110 ft 80% 5% 75 of 75
California 180 ft 34% 6% 53 of 58
Colorado 86 ft 73% 2% 59 of 64
Connecticut 92 ft 89% 0% 9 of 9
Delaware 70 ft 100% 0% 3 of 3
District of Columbia 38 ft 100% 0% 1 of 1
Florida 160 ft 49% 18% 65 of 67
Georgia 280 ft 13% 33% 139 of 159
Hawaii 263 ft 0% 25% 4 of 5
Idaho 167 ft 43% 7% 44 of 44
Illinois 128 ft 59% 19% 75 of 102
Indiana 92 ft 80% 0% 60 of 92
Iowa 218 ft 24% 12% 98 of 99
Kansas 60 ft 84% 1% 101 of 105
Kentucky 75 ft 94% 0% 104 of 120
Louisiana 202 ft 30% 16% 64 of 64
Maine 46 ft 100% 0% 14 of 16
Maryland 152 ft 50% 0% 24 of 24
Massachusetts 65 ft 100% 0% 14 of 14
Michigan 93 ft 86% 0% 35 of 83
Minnesota 128 ft 62% 1% 87 of 87
Mississippi 170 ft 37% 10% 82 of 82
Missouri 260 ft 30% 28% 110 of 115
Montana 97 ft 69% 4% 54 of 56
Nebraska 142 ft 52% 0% 91 of 93
Nevada 185 ft 29% 0% 17 of 17
New Hampshire 197 ft 20% 0% 10 of 10
New Jersey 139 ft 62% 0% 21 of 21
New Mexico 180 ft 36% 6% 33 of 33
New York 84 ft 87% 2% 62 of 62
North Carolina 120 ft 71% 1% 99 of 100
North Dakota 92 ft 81% 2% 53 of 53
Ohio 93 ft 70% 1% 69 of 88
Oklahoma 67 ft 93% 0% 75 of 77
Oregon 227 ft 37% 14% 35 of 36
Pennsylvania 125 ft 69% 0% 67 of 67
Puerto Rico 88 ft 88% 2% 43 of 78
Rhode Island 60 ft 100% 0% 4 of 5
South Carolina 252 ft 21% 12% 33 of 46
South Dakota 114 ft 65% 8% 66 of 66
Tennessee 154 ft 47% 4% 47 of 95
Texas 244 ft 32% 29% 105 of 254
Utah 161 ft 46% 4% 28 of 29
Vermont 163 ft 38% 0% 8 of 14
Virginia 260 ft 17% 22% 77 of 133
Washington 126 ft 67% 0% 39 of 39
West Virginia 84 ft 93% 0% 55 of 55
Wisconsin 132 ft 61% 3% 72 of 72
Wyoming 120 ft 70% 0% 23 of 23

How to read it

A state median hides more than it shows. Within one county, valley alluvium and upland bedrock are different aquifers that happen to share a courthouse, so the spread between two parcels a few miles apart is often bigger than the difference between counties. Use the state figure to decide where to look, then the county layer to compare places, then a well log or a local driller for the parcel itself.

Counties with too few wells on record to give a fair median are left out, which is why some states show fewer counties with data than they have. These are depths of wells that were drilled and recorded, not a survey of the water table, and say nothing about yield or quality.

Where it comes from

USGS NWIS national groundwater site inventory, aggregated by county. Data release 2 October 2026. The same county medians are the Well Depth layer in the complete map, where every county is shaded in five depth bands and clickable for its median and 25–75 spread, and where British Columbia, Alberta, Ontario and Quebec are covered too.

Buy — all 35 layers, $49 Your state's county ranking, free